DIY

How Much Sand Do You Need?

Built by Kevin Glover · @gloverbuilds · Verified formula

Calculate tons or cubic yards of sand for paver base, sandbox, leveling, and masonry.

📅 Updated April 2026 ✅ Formula verified 📖 4 min read 🆓 Free · No sign-up

In this article

Sand Types and Uses
How Much for Common Projects

Berechnung

Tonnen = Fläche × Stärke (m) × 1,5. 20 m² bei 5 cm: 1,5 t. Spielsand: 20-30 €/t. Pflastersplitt: 25-40 €/t. Für den Sandkasten: gewaschener, zertifizierter Spielsand verwenden (DIN EN 71-3). In Deutschland gibt es strenge Normen für Spielsand.

Typen

Estrichsand (0-8 mm): Beton, Estrich. Füllsand: Auffüllung, Drainage. Spielsand: gewaschen, geprüft. Quarzsand: Fugen, Filteranlagen.

⚡ CalcWolf Insight

Sand compacts about 15% when tamped. For a 1-inch finished bedding layer under pavers, spread 1.15 inches of loose sand before screeding. Use 1-inch diameter pipes as screed rails — lay them on the gravel base, pour sand between, and drag a straight board across the tops.

Frequently asked questions

Wie viel für Sandkasten 2×2 m?▾

Bei 20 cm: 2×2×0,2×1,5 = 1,2 t. Spielsand: ~30-40 €.

Lose oder Sackware?▾

Lose bei mehr als 0,5 t. Sackware für Kleinmengen.

✓ Math logic verified against primary sources → See our verification process

Kevin Glover · @gloverbuilds

Founder, CalcWolf · GLVTS · Blickr

All formulas sourced from primary references — IRS publications, peer-reviewed research, and official standards. Results are tested against independent reference calculators before publishing. Rates and brackets updated when official sources change. Editorial policy →